A clean, minimal under-desk cage mount for the Apple Mac Studio. It bolts directly to the underside of your desk with 6 screws through the solid top plate — your Mac hangs securely below, out of sight, and your desk surface stays completely clear.
Installation is refreshingly simple: screwdriver access slots in the base let you tighten the top screws from below without ever removing the cage, and the 14mm front retaining lip keeps your Mac Studio locked in place while the open back gives you full access to every port.
Apple®, Mac Studio® and Mac mini® are trademarks of Apple Inc. This is an independent Formada3D design made to fit those products — not affiliated with, sponsored or endorsed by Apple.
Designed and 3D printed in-house in Melbourne, Australia. Made to order in 3–5 business days and carefully packaged. Custom colours available — just message us!
Need a different hole pattern? We can print this mount with custom mounting holes for your desk, arm or bracket. Send us the spacing through the quote page and we'll confirm the price before printing.
Installation & use. Designed to hold the Mac Studio only. Mount it to a solid desk in good condition, following the included guide, with screws or bolts suited to your desk (not included). Check the fixings are tight before use and every few months, and don't load anything else on it. Not covered: damage caused by incorrect installation, unsuitable surfaces, modification, impacts, or loads beyond what it is designed for. This doesn't affect your rights under the Australian Consumer Law.
Colour & finish. Each piece is printed to order, so slight colour or sheen differences can occur between filament batches. Fine layer lines are part of the 3D-printed finish. This doesn't affect strength or fit.
Does this fit any desk, or only a Secretlab desk?
This cage mounts with M5 × 12mm wood screws into the underside of your desk, so it fits any desk you can screw into — it isn't limited to a particular desk brand.
Is mounting hardware included?
No — mounting screws are not included. It uses M5 × 12mm wood screws, which most hardware stores stock.
What material is the Mac Studio Under-Desk Mount (Horizontal) — Ventilated Cage with Screwdriver Access printed in?
Printed in PETG — rigid, heat-resistant and built to last under a desk without sagging or warping over time. Every order is printed to order in Melbourne, so there's no mass-production waste and nothing sitting in a warehouse.
How long does shipping take?
Australia: $10 standard / $15 express, free standard shipping over $100 · New Zealand: $15 · United States: $20 · Other countries: $25. Every item is printed to order and ships in 3–5 business days from Melbourne. Returns per Australian Consumer Law — if it arrives faulty or not as described, we make it right.
Where is it made?
Designed and 3D printed to order in our Melbourne, Australia workshop.
What's your returns policy?
Returns are handled per Australian Consumer Law — if it arrives faulty or not as described, we make it right.
✓ check your inbox — code's on the way
FORMADA
