Real print-cam timelapse — this exact product printing in our Melbourne studio
Free up your desk space with this precision-engineered under-desk cage mount, purpose-built for the Apple Mac Studio and the Secretlab Magnus Pro desk. Your Mac Studio eats valuable desk space, cable routing gets messy, and generic desk mounts costing $200+ don't even fit properly — this custom cage slides your Mac Studio neatly under the desk instead.
The headline feature: a front retaining lip. This raised front ledge cradles the leading edge of the Mac Studio so it can't slide or vibrate forward out of the cage — a rock-solid, no-drop hold — while the front stays fully open for port access.
Apple®, Mac Studio® and Mac mini® are trademarks of Apple Inc. This is an independent Formada3D design made to fit those products — not affiliated with, sponsored or endorsed by Apple. Secretlab® and Magnus Pro™ are trademarks of Secretlab SG Pte. Ltd.; this product is not affiliated with, sponsored or endorsed by Secretlab.
Designed and 3D printed in-house in Melbourne, Australia. Made to order in 3–5 business days and carefully packaged. Custom colours available — just message us!
Need a different hole pattern? We can print this mount with custom mounting holes for your desk, arm or bracket. Send us the spacing through the quote page and we'll confirm the price before printing.
Installation & use. Designed to hold the Mac Studio only. Mount it to a solid desk in good condition, following the included guide, with screws or bolts suited to your desk (not included). Check the fixings are tight before use and every few months, and don't load anything else on it. Not covered: damage caused by incorrect installation, unsuitable surfaces, modification, impacts, or loads beyond what it is designed for. This doesn't affect your rights under the Australian Consumer Law.
Colour & finish. Each piece is printed to order, so slight colour or sheen differences can occur between filament batches. Fine layer lines are part of the 3D-printed finish. This doesn't affect strength or fit.
Does this fit the Secretlab Magnus Evo, or only the Magnus Pro?
This mount is engineered specifically for the Secretlab Magnus Pro's M5 bolt pattern (8 pre-drilled holes) — it is not designed for the Magnus Evo or other desks. Need a different hole spacing? Send us the measurements through the quote page and we'll confirm the price before printing.
Is mounting hardware included?
No — mounting hardware is not included. It uses M5 bolts through the 8 pre-drilled holes designed for the Magnus Pro's accessory mounting points; M5 bolts are stocked by most hardware stores.
I have a Mac mini, not a Mac Studio — do you make a mount for that?
Yes — see our Mac Mini M4 Under-Desk Mount for Secretlab Magnus Pro, built the same way for the Mac mini's smaller footprint. We also offer a combo mount that holds a Mac Studio and a Mac mini together.
What material is the Mac Studio Under-Desk Cage Mount — for Secretlab Magnus Pro printed in?
Printed in PETG — rigid, heat-resistant and built to last under a desk without sagging or warping over time. Every order is printed to order in Melbourne, so there's no mass-production waste and nothing sitting in a warehouse.
How long does shipping take?
Australia: $10 standard / $15 express, free standard shipping over $100 · New Zealand: $15 · United States: $20 · Other countries: $25. Every item is printed to order and ships in 3–5 business days from Melbourne. Returns per Australian Consumer Law — if it arrives faulty or not as described, we make it right.
Where is it made?
Designed and 3D printed to order in our Melbourne, Australia workshop.
What's your returns policy?
Returns are handled per Australian Consumer Law — if it arrives faulty or not as described, we make it right.
✓ check your inbox — code's on the way
FORMADA
